Repository logo
Communities & Collections
All of DSpace
  • English
  • العربية
  • বাংলা
  • Català
  • Čeština
  • Deutsch
  • Ελληνικά
  • Español
  • Suomi
  • Français
  • Gàidhlig
  • हिंदी
  • Magyar
  • Italiano
  • Қазақ
  • Latviešu
  • Nederlands
  • Polski
  • Português
  • Português do Brasil
  • Srpski (lat)
  • Српски
  • Svenska
  • Türkçe
  • Yкраї́нська
  • Tiếng Việt
Log In
New user? Click here to register.Have you forgotten your password?
  1. Home
  2. Browse by Author

Browsing by Author "Supervisor 2: Nikita Abramov"

Filter results by typing the first few letters
Now showing 1 - 1 of 1
  • Results Per Page
  • Sort Options
  • Thumbnail Image
    Item
    Revised Scope: Design and Implementation of a Portable Bus-Powered Dual-Mono USB-C DAC/AMP on the XMOS XU208 Platform
    (German-Mongolian Institute for Resources and Technology (GMIT), 2026) Gal, Unubold; Supervisor 1: Kim Young Suk, PhD.; Supervisor 2: Nikita Abramov
    This thesis documents the design and implementation of a portable, bus-powered USB-C digital-to-analog converter and headphone amplifier (DAC/AMP) on a 4-layer mixed-signal PCB. A review of the commercial portable DAC/AMP market shows that budget and mid-range devices typically rely on single-stereo DAC architectures, PLL-derived clocks and limited power distribution, while XMOS XU208-based designs have so far been restricted to desktop devices. The design evolved through two architectures and three revisions. Version 1, a desktop architecture, produced simulation work including a MOSFET-based capacitance multiplier achieving -112.12 dB power-rail SNR. Version 2 initially used the CT7601CR MCU, which was replaced by the open-source XMOS XU208 USB audio processor due to its closed firmware ecosystem. The final design implements a true dual-mono architecture with two independent CS43131 DAC/AMP chips, three independent crystal oscillators for jitter-free master clock distribution, and a cascaded power distribution network (TPS7A9101, LT3045 and SGM2036 regulators) that isolates the analog supply chain from USB VBUS noise. It provides both 3.5 mm single-ended and 4.4 mm balanced outputs within the USB 2.0 500 mA current budget. Design decisions were based on manufacturer design guides, datasheets and established EMC literature, and a failure mode and effects analysis (FMEA) was performed on the final revision. The fabricated board is ready for assembly, and a three-phase verification methodology (power-on, firmware bring-up and audio performance measurement) is defined to validate the theoretical performance in hardware.

DSpace software copyright © 2002-2026 LYRASIS

  • Privacy policy
  • End User Agreement
  • Send Feedback
Repository logo COAR Notify